FAQ
- How do I fix my tacky and gooey surface?
- Fiber Lok is thick and dried out looking, Can it still be used?
- What di I do if my Fiber Lok rug backing is too thick to spread?
- Can I wash and dry my rug after applying Fiber Lok rug backing?
- How long does it take for Fiber Lok rug backing to dry?
- How do i figure out how much Silicone Rubber to buy?
- Which silicone do you recommend for smaller molds?
- Which silicone do you recommend for doing large molds?
- How do i clean a mold with uncured resin in it?
- Why are lines visible in my layers of Polyester Casting Resin?
- I'm using your Polyester Casting Resin, Why is the surface tacky to the touch on the open part of the mold?
- Why does my Polyester casting Resin have a strong chemical odor?
- When using your Polyester Casting Resin, Why use less catalyst on larger projects?
- How do i remove bubbles from my casting?
- How do I get EasyCast unstuck from my mold?
- Why is my EasyCast cloudy?
- How can i get EasyCast unstuck from my mold?
- Why is my EasyCast curining so slowly?
- Why is my EasyCast soft after the recommended cure time?
- Why is my EasyCast sticky after curing?
- How can i remove cured epoxy from my project?
- Can i use a drill with a mixing attachment to mix my epoxy?
- Can your Epoxy be colored? What can i use?
- How do I keep the coating from going over the project edge?
- How to remove drips from the underside?
- What wont the Epoxy adhere to?
- Can wood be stained?
- How to achieve a satin finish?
- Why does my coated surface have hard crystal like pebbles in it?
- My coating looks dull with a spider web look?